You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Battling with a 3Q0035819A unit (MIB STD2 ZR SW 0240 HW H24, MST_EU_VW_ZR_P0240T). Have updated firmware to P0254T. Going to redo the solder joints this week to connect eMMC to QNX VM and install toolbox that way.
Unfortunately, dev mode is not enabled and skint right now to buy a subscription to ODBEleven.
Is there a way to enable dev mode direct on firmware with the eMMC connected to the QNX VM? I've seen it done with MIB2 High units, etc.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
Uh oh!
There was an error while loading. Please reload this page.
-
Battling with a 3Q0035819A unit (MIB STD2 ZR SW 0240 HW H24, MST_EU_VW_ZR_P0240T). Have updated firmware to P0254T. Going to redo the solder joints this week to connect eMMC to QNX VM and install toolbox that way.
Unfortunately, dev mode is not enabled and skint right now to buy a subscription to ODBEleven.
Is there a way to enable dev mode direct on firmware with the eMMC connected to the QNX VM? I've seen it done with MIB2 High units, etc.
Any help appreciated.
Beta Was this translation helpful? Give feedback.
All reactions